AirPac COOLIT3000 Instruction Manual - page 7
15
Your COOLIT3000 is designed for easy maintenance.
Performing routine preventive maintenance will ensure you
enjoy years of trouble-free operation and keep your unit
running at peak efficiency.
Before any maintenance make sure the unit has stopped
running and unplug the unit from the electrical outlet.
The air filters will accumulate dust and dirt when operating in
the cooling and fan functions. It is important to keep the
filters clean so the air flow is not restricted and cooling is
optimized. To clean filters:
Evaporator Filters
1.
Open front door of the unit.
2.
Remove the filter and clean or replace. Filters
shipped with the unit can be cleaned with water.
3.
Replace the filter with new or cleaned filter.
4.
Close the front door and resume operation.
Condenser Filters
1.
Open back door of the unit.
2.
Remove the filter by cutting the plastic tie wrap,
clean or replace filter.
3.
Close the front door and resume operation.
Turn off the unit and unplug it from the electrical outlet.
Clean the interior of each tank to avoid growth of mold and
mildew. Flush the tank with a solution of warm water and
mild detergent before storage.
Before storage or shipping—Operate the unit in fan mode
for minimum of 30 minutes. Turn off and let stand for 1
hour to allow all condensate to drain off coil. Remove tanks
and empty water. Remove condensate pump and dump out
all water in pump reservoir. Separate pump from reservoir
and wipe inside dry.
MAINTAINING THE UNIT
General
Maintenance
Clean the Air
Filters
Clean the
Condensate
System
INSTALLING COOLIT3000
Set up Your
COOLIT
Check out
Your COOLIT
1. Remove COOLIT packaging.
Unpack and inspect the unit for visible shipping damage.
If you find shipping damage, DO NOT OPERATE THE
UNIT. Keep all packaging.
2. Remove COOLIT from skid.
The COOLIT is immobilized on the skid by eight wooden
blocks. Each block is secured with two screws. Remove
the screws from each of the blocks and remove the blocks.
Now slide the COOLIT3000 to the side to remove the unit
from the skid.
3. Place the unit on a flat, solid surface.
Operation on uneven s urfaces may cause vibration, noise
and possible water leakage from condensate system .
4. Check that the condensate water tanks are in place and
properly seated.
If the condensate tank is not installed properly the unit will
not operate. The COOLIT has a unique condensate
removal system that is integral to the unit. Refer to the
Automatic Condensate Draining section on page 13 to use
this feature.
If using an extension cord: extension cord
must be rated at least 20 amps, at 250 volts
and have a grounding type attachment plug
connector (load fitting).
CAUTION:
4
Power Your
COOLIT
5. Plug COOLIT unit into a NEMA L6-20 outlet.
Remove cord from cord storage area. Plug unit directly
into the appropriate wall outlet.
Do not plug COOLIT into ex-
tension cord. When power is
applied to the unit, theLED
display will read “OFF”. There
will be a small LED light com-
ing from behind the access
door to indicate voltage is be-
ing applied to the unit.