AirPower Models F-16 EDF JET Instruction Manual - page 2
AirPower F - 16 EDF JET Instructions Manual
You can get our company details at :
AirPower Models Co., Ltd.
Taiwan Head office http://www.airpowernet.com
AirPower Models Co., Ltd.
UK http://www.airpowerrc.com
2
Introduction
Thank you for purchasing the Airpower F16 fighter jet. As you will see this is an extremely easy to build jet but as it’s not a
beginner’s model, we would suggest some flying experience is required. These instructions are a guide and assume you
have assembled kits before if you need help ask an experienced person for advice.
The model will come together in no time at all using very simple yet modern building techniques meaning that no special
tools or equipment is required. As this model can be used as an EDF (Electric Ducted Fan) or a Pusher (motor mounted at the
rear using a propeller) it is up to you depending on your budget what you wish to do.
NOTE: THIS IS NOT A TOY.
Please make sure you have BMFA (British Model Flying Association) insurance and if you are not experienced take a
seasoned model pilot with you when flying.
Section one
Parts check:
1. fuselage
top:
2. fuselage
bottom
3. right
wing
4. left
wing
5.
6. right
elevator
7. left
elevator
8. vertical stabiliser
9. canopy
10. nose cone
11. double sided tape sheet
12. accessories
13. push rods X 3
14. small bag of screws, washers and bolts
15. Ply mount for pusher version.
NB: please note that the white plastic accessory moulding is for several models and not all of the items will be used with this
kit, in fact, only the four control horns are needed.
If you are building your F16 as a ‘pusher jet refer to details at the very end of these instructions.