AirPower Models F-16 EDF JET Instruction Manual - page 7
AirPower F - 16 EDF JET Instructions Manual
You can get our company details at :
AirPower Models Co., Ltd.
Taiwan Head office http://www.airpowernet.com
AirPower Models Co., Ltd.
UK http://www.airpowerrc.com
7
Step five:
Servo installation
5. You will need 4 servos one for each moving surface. Simply remove the mounting lugs from the servos and
draw around them making sure to align the servo arm with the control horn. When happy, remove the foam
leaving a hole for the servo to fit in to. After centring them, secure each servo using double-sided foam tape.
(Pictures 16,17,18)
P.16
P.17
P.18
Tip: Tape the wings and tail planes in position at this stage so make sure all lines up prior to fitting the servos.
NB: take note of the servo positioning for the elevators. Make sure that they line up with the control horns and
that they are not a mirror image of one another. One arm should be near the horn (LHS) and the other away from
the horn (RHS). Both horn splines should be pointing either to the right, as above, or to the left.
Tip: you will need to connect both elevator servos together in a Y-lead fashion. This will leave you with a single
male end to insert in to the Rx.
Feed the servo wires through the sides of the fus and if required extend the wires to reach the receiver, which
will be secured in the moulded recess between the wings on the upper fus. (Picture 17)
Now is a good time to make up four control rods, one for each servo. Cut them about 7cm long. You will need to
cut them from the supplies rods in the kit and Z bend the ends. (Picture19
Control rods:
P.19