AirPower Models F-16 EDF JET Instruction Manual - page 3
AirPower F - 16 EDF JET Instructions Manual
You can get our company details at :
AirPower Models Co., Ltd.
Taiwan Head office http://www.airpowernet.com
AirPower Models Co., Ltd.
UK http://www.airpowerrc.com
3
Step one:
Wings ailerons and horizontal stabilisers.
1: take one wing section and place on a firm surface with the red finish facing upwards.
1a. hold the wing down with one hand lift and rotate the aileron with the other and totally fold it back on itself.
Then using something firm (we used a small battery but you can use anything at all) depresses the internal
edges of the depron to allow maximum movement of the aileron in both directions. (Picture 1)
P.1
1b. then do exactly the same for the whole wing and depress both internal edges of the LE (leading edge) Picture
2
P.2
1c. unfold the wing, bringing the red finish to the outside and remove the protective covering from the bonding
strip and bring the upper and lower surfaces of the wing together. (Pictures 3&4). Before pressing the two TE
together, warm the bonding tape a little with a hair dryer and press down firmly until both surfaces are bonded.
This takes about 60 seconds. To make it more secure you can apply clear selotape to the TE.
P3
P4