AirPower Models F-16 EDF JET Instruction Manual - page 4
AirPower F - 16 EDF JET Instructions Manual
You can get our company details at :
AirPower Models Co., Ltd.
Taiwan Head office http://www.airpowernet.com
AirPower Models Co., Ltd.
UK http://www.airpowerrc.com
4
Tip: you may feel that the film covering will split or that both surfaces will not come together. Do not worry, as it
is this state of tension that creates the mechanical strength that stiffens the wing.
This completes the wing construction. Move the aileron up and down several times to obtain full movement.
FOLLOW THE EXACT SAME PROCEDURE FOR THE OTHER WING AND HORIZONTAL STABILIZERS. (Picture 6
and 7)
P.6
P.7
By now you should have constructed two wings and two horizontal stabilisers that can be put to one side.
Next, insert the four control horns. Their positions are marked on the elevators and ailerons. Simply cut through
with a sharp blade (from the top) and push them through securing from underneath with the plastic retaining
clips.
See Picture 8 below:
P.8
Step two:
Vertical fin.
2. The method of construction for the vertical fin is the same as the wings and horizontal stabilisers. Place on a
firm surface with the decals facing up and fold back on itself and using the same implement as you did for the
wings compress the inner surfaces of the leading edges. Then fold both sides back on them selves and remove
the protective strip and warm the bonding tape with a hair dryer and press the two sides together and hold firmly
for about 60 seconds. (Picture 9)
P.9