AirPower Models F-16 EDF JET Instruction Manual - page 5
AirPower F - 16 EDF JET Instructions Manual
You can get our company details at :
AirPower Models Co., Ltd.
Taiwan Head office http://www.airpowernet.com
AirPower Models Co., Ltd.
UK http://www.airpowerrc.com
5
Step three:
Fus Preparation
3. Locate both top and bottom mouldings of the fus and remove the areas indicated with the blue line. (Pictures
10/11. Use a new blade and keep the internal surface as smooth as possible. If opting for the pusher set up this is
not required.
P.10
P.11
3a. In order for the fan to breathe a cheater hole is required. The opening has to be in front of the fan and have an
area of aprox 104cm. The easy way to achieve this is to take a piece of card measuring 13cm X 8cm and cut it out.
Then place it into the inside of the bottom fus moulding and draw around it. Remove the card then cut away the
foam. (Pictures 12&13) When removing the foam make sure the scalpel blade is kept vertical.
Tip: keep this foam as it is used to cover this hole back up if building a pusher jet.
P.12
P.13
3b. Remove the foam from the intake at the front of the fus lower section. (Picture 10)
Now remove the foam from under the canopy floor (upper fus moulding) creating a hole for the battery pack. As a
guide follow the moulded edge.