AirPower Models F-16 EDF JET Instruction Manual - page 6
AirPower F - 16 EDF JET Instructions Manual
You can get our company details at :
AirPower Models Co., Ltd.
Taiwan Head office http://www.airpowernet.com
AirPower Models Co., Ltd.
UK http://www.airpowerrc.com
6
Step four:
Fan Installation
4. Install the motor in to the fan unit. Extend the wires from the motor such that they reach the ESC, this can be
placed wherever you want on the inside of the fus. Try and keep these wires as short as possible. Then trial fit
the assembly in to the lower fus moulding. (Picture 14)
P.14
4a. Fold some sand paper around a bottle and sand smooth the internal surfaces (Picture 15)
P.15
4b. The wires that come from the motor to the ESC can be passed through the space under the fan mounting
lugs (pic 13) make a shallow groove, just deep enough to bury the wires. Tack tape them in place until later.
Tip: make sure the mounting lugs correspond to the mounting grooves in the upper fus section on final
assembly.
NB: as this is not a beginners model it is assumed that all relevant connectors have been soldered to the wires
prior to installing.
4c.Trial fit the two sections of the fuselages together to make sure no fouling is evident and when happy
separate them and leave to one side.