B&K AVP1030 Owner's Manual - page 12

Page 10

11. FM antenna

input - 

Connection for the FM antenna.  75 Ohms.

12. Tape Loop - 

 Connections for the audio of a tape deck.

TAPE OUT- Provides a fixed level, buffered audio output for sending to a tape

player.  Connect the TAPE OUT from the AVP to the TAPE IN on

the tape player.  

TAPE IN -

Accepts audio output from a tape player.  Connect the TAPE IN

from AVP to the TAPE OUT on the tape player.

13. V1 loop -

Connections for the audio of a VCR designated as VCR 1.

V1 OUT -

Provides a fixed level, buffered audio output for sending to a  VCR. 

Connect the V1 OUT on the AVP to the AUDIO IN on the VCR.

V1 IN -

Accepts audio output from a VCR.  Connect the V1 IN on the AVP

to the AUDIO OUT on the VCR.

14. V2 loop -

Connections for the audio of a VCR designated as VCR 2.

V2 OUT -

Provides a fixed level, buffered audio output for sending to a  VCR.  

 Connect the V2 OUT on the AVP to the  AUDIO IN on the VCR.

V2 IN -

Accepts audio output from a VCR.  Connect the V2 IN on the AVP

to the AUDIO OUT on the VCR.

15. CTRL OUT -

Output that allows you to remotely control external devices.  This

output is rated at 12 VDC @ 15 mA continuous.  The output goes

high (12 VDC) when the preamplifier is turned on, and low (0 VDC)

when the preamplifier is turned off.  This output works with the B&K

amplifiers to remotely turn them on and off (amplifiers with the

control feature).  Connect the CTRL OUT on the AVP to the CTRL

IN on the amplifier.  

15. IR IN -

Accepts input from external IR receptors.  Connect  your IR

repeater to IR IN to control the AVP preamplifier when the front IR

receiver is blocked (by cabinet door).