B&K AVP1030 Owner's Manual - page 17

Page 15

 '&

and attach it to the cable near both ends.  This makes it easy to identify.

@

To ensure maximum safety, keep all cables out of high traffic areas (hallways or

doorways) and away from equipment that radiates power, including amplifiers,

power cords, heaters, etc.

@

If you might expand your audio/video system later, keep these ideas in mind as

you plan current cable runs.

Factory reset

Reset the AVP before you start.  Plug in the power and turn the AVP on.  When the

display shows:    

Press the

7

(star) then 9 then 8 and the display will show:

The AVP will turn off and back on. Then it will cycle through the three title messages

and then off again.  The AVP is now reset to factory defaults.  You can perform this

procedure anytime you need to reset the preamplifier to the factory defaults.  

All your

presets will be erased.

  Do not interrupt the cycle, do not press any buttons

on the remote or preamplifiers face plate.  If you accidentally press a button, you will

have to repeat the reset procedure.

Turn the preamplifier ON and the display will show:

You can now program the preamplifier to your desired setup.