B&K AVP1030 Owner's Manual - Using Presets

Page 26

You have completed the setup procedure.  Remember, you have to perform the 

calibration procedure every time you change your speaker configuration.

Using presets

There are 20 A/V presets provided.  Presets “0" through “9" are selected using the

numeric buttons on the remote (0-9).  Pressing the “A” button first allows you to select

bank “A” presets, “A0" through “A9", using the same numeric buttons (0-9).

The preprogrammed audio/video presets let you instantly select any of the audio/video

sources along with volume level and surround mode settings.  You can customize the

presets, including the preset name, for ease of operation.

Recall a preset

Using the remote control, press a number on the keypad to display the preset name. 

Pressing “A” selects “bank A”.  Once you press a preset number, you can then press 

x

or 

y

 to step through all the preset names.   If the AVP is off, pressing a preset number

will turn the preamplifier on, then pressing ENTER will select that preset.

Keypad

Display shows

Keypad

Display shows

number

number

0

5

1

6

$   

2

7

%  

3

8

!  

&  

4

9

"  

'  

Select the desired preset then press ENTER to recall.  The display will show (if you

selected preset #1):

Save a preset

A preset will save the following information in a preset for you:

Master volume, Selected input, Input mode (analog, PCM, or Dolby Digital)

Surround mode, rear volume, subwoofer volume, center channel volume, delay