Bacharach Microprocessor Module Replacement Kit Instruction Manual - page 2
Microprocessor Module Replacement Kit for Multi-Zone Leak Monitors
2
3015-5547 Rev 4
NODE ADDRESS = _________
NUMBER OF ZONES = __________
ZONE
(From
screen)
LOCATION
(Based on your
physical installation)
GAS
LENGTH
OF
TUBING
TEMP
AT
ZONE
STORED ALARM LEVELS
LEAK
LEVEL
SPILL
LEVEL
EVAC
LEVEL
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
4. Removal Preparation
Prepare to remove the old microprocessor module by following the steps below.
a. Disconnect power to the leak monitor and confirm that no power is present.
WARNING
Failure to remove power can cause damage to the monitor and can cause personal injury
or death.
b. Remove the two screws on the left edge of the front panel.
c. Open the front panel and ground your body by touching an area of bare metal.
WARNING
Failure to touch the grounding area can allow static electricity on your clothing or body to
damage the monitor or modules. Such damage is not covered under warranty.
d. Disconnect the 12-position screw terminal to prevent activating alarm equipment.