Barco R9002380 Installation Manual - G2 Adjustment
G2 Adjustment
7-1
5976067 BARCOCINE 7 151299
SERVICE MODE
ADJUSTMENT MODE
Select a path from below :
IRIS
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
Select with or
then
7
G2 ADJUSTMENT
G2 adjustment
How to start up the G2 adjustment ?
1. Enter the adjustment mode by pressing ADJUST (menu 1).
2. Highlight
Service.
3. Press ENTER to start up the service mode.
4. Highlight 'Common settings' (menu 2).
5. Press ENTER.
6. Highlight G2 adjust (menu 3)
7. Press ENTER.
A safety notice will be displayed to warn the operator (menu 4).
If you are qualified, press ENTER to continue with the G2 adjustment, otherwise press EXIT to return to the service menu.
If ENTER is pressed, the G2 menu will be displayed (menu 5).
Select with or
then
Select with or
then
COMMON SETTINGS
G2 ADJUSTMENT
CRT RUN IN CYCLE
PROJECTOR WARM UP
I2C DIAGNOSTICS
Select color with
ç
or
è
G2 ADJUSTMENT
RED
ABL : ON
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
IF QUALIFIED, PRESS
IF NOT,
SAFETY
NOTICE
RISK OF ELECTRICAL SHOCK
G2 ADJUSTMENT SHOULD
BE PERFORMED BY BARCO
PERSONNEL OR BARCO
AUTHORIZED DEALERS
image 1
image 2
image 3
image 4
image 5
How to adjust the G2 ?
Open the top cover to reach the G2 controls and adjust these G2 controls for red, blue and green separatly.
The controller automatically increases brightness and contrast until the raster behind the displayed text becomes visible.
Look to the projected image and observe the raster behind the image while the ABL function is ON.
Switch ABL to OFF by pressing ENTER and adjust the G2 control until the raster brightness looks the same as when the ABL function
is ON.