Bauhn HE215041 Instruction Manual - Installation
9
After Sales Support - Help Desk
Telephone:
1300 663 907
Internet:
www.winplus.com.au
Installation
The Bauhn Indoor Remote Controlled Power Points can be used all around the home or office to
turn your appliances on or off with a remote control.
2.1 Pairing the Power Point Controllers to your remote
1. Unpack contents from the packaging. Check you have all components from the parts list.
2. Remove the tab from the rear of the remote control to activate the batteries.
3. Connect the device you wish to control to the socket of your power point controller.
4. Insert the Power Point Controller into any power outlet.
5. Turn on the power outlet. The LED on the Power Point Controller will begin to flash slowly.
6. Using the remote control, press the ON button next to the number you wish to assign the
Power Point Controller to.
Example: Press ON next to the number 1 to assign the Power Point Controller to the number 1 ON/OFF
buttons.
7. The LED on the Power Point Controller will begin to flash quickly to confirm it has successfully
paired to the remote.
8. Repeat the above steps to pair the remaining Power Point Controllers.
NOTE: You can set up multiple Power Point Controllers to be in a group by performing the pairing
procedure and selecting the same number on the remote control for each Controller.
2.2 Using the Remote Control
Once you have paired your Power Point Controllers to the remote you can control the Power Point
Controller from up to 30m away.
1. Press the ON button on your remote control which has been paired with the Power Point
Controller you wish to use.
2. The Power Point Controller LED will light up when ON.
3. If you wish to control all the Power Point Controllers paired to the remote control, press the ON
or OFF buttons marked “ALL”.
Note: Certain materials, walls, floors and wireless interference from other devices may limit the range. If
possible, move these devices away from the Power Point unit to improve the transmission distance.