Bully Dog OutLook Installation Manual - Outlook Installation
9
OuTLOOK INSTALLATION
Intr
oduc
tion
Harness D
escription
Oper
ating Instruc
tions
Pyr
omet
er P
robe C
alibr
ation
Troubleshooting
IMPORTANT: This step is performed on all vehicles.
Dodge: Fuse #28
Ford: Fuse #33
GM Fuse “ING E”
OBD II Port
OutL
ook Installa
tion
INSTALLING THE OBD II HARNESS
In this step you will connect the OBD II plug, page 2 #6, connect the
power wire, and run the green connector through the fire wall.
CONNECTING THE OBD II PLUG:
Plug the OBD II Harness into the OBD II Port located on the bottom side of the
dash on the driver’s side of the vehicle.
CONNECTING THE yELLOw POwER wIRE:
1. Prepare the yellow power wire by stripping the end of the wire about
¼”. Connect the blue 90° connector to the end of the Power Wire using
crimping pliers. The location may vary depending on vehicle make.
2. Locate the fuse box: Ford fuse boxes are located under the dash inside
the cab of the vehicle; Dodge & GM fuse boxes are located usually on the
drivers side of the inside of the engine bay. Please see your owners manu-
al for more details on fuse box locations. Once inside the fuse box, locate the
appropriate fuse depicted in the vehicle-specific pictures below.
3. Remove the fuse, indicated in the picture below, and insert the fuse jack.
Make sure that the fuse jack is placed on the dead side of the fuse to
ensure that the OutLook monitor is protected by the fuse as well. Use a
volt meter to verify the dead side of the fuse. With the fuse pulled and
the truck powered on but not started, the volt meter should read 0 volts
on the fuse jack to ground. Problems that can occur if the incorrect fuse is
used for this connection: the power may stay on continuously even with
the key off; or, the OutLook monitor can receive power at the incorrect
time of the power-on/starting cycle of the vehicle.
4. Connect the yellow power wire to the fuse jack, place the fuse back into the slot, and close the fuse box.
GREEN PLUG THROUGH THE FIRE wALL:
1. Run the end of the OBD II Harness with the green plug and the yellow power wire on GM & Dodge trucks, through
the fire wall. The yellow power wire will plug into the fuse box inside the cab on the Ford Power Stroke.
2. Set the green male connector in the back corner of the engine bay on the driver’s side of the vehicle and leave it while
hooking up any other harnesses.
wARNINg: For the OutLook to function properly, all fuses must be pushed in completely.
OBD II Harness (#6)
Yellow Power Wire w/90º connector