Bully Dog OutLook Installation Manual - Operating Instructions
20
Intr
oduc
tion
Harness D
escription
OutL
ook Installa
tion
Pyr
omet
er P
robe C
alibr
ation
Troubleshooting
View Last 10 Readings
Quarter Mile Times
0-60 Times
Peak Boost / Start Cycle
Peak Pyro / Start Cycle
Clear Top Ten Values
View All-time Highs
Quarter Mile Times
0-60 Times
Clear Top Ten Values
Set Pyrometer Probe De-fuel level
900º
950º
1000º
1050º
1100º
1150º
1200º
Set Transmission De-fuel level
180º
190º
200º
210º
220º
230º
240º
OPERATING INSTRuCTIONS
Opera
ting Instruc
tions
MAIN MENU ITEMS
SET PyROMETER PROBE DE-FUEL LEvEL:
With this menu
option a list of temperatures ranging from 900˚F up to 1700˚F
is presented. Based upon where you have installed the Pyrometer
Probe (see installing the Pyro Instructions), you will use this op-
tion to select the highest temperature you ever want your exhaust
gas to reach when de-fueling. We recommend that you use our
Pyrometer Probe Calibration Procedure to find out what your Pyrometer Probe de-fuel level will be. Once a de-fuel
level is put in place, if the Exhaust Gas Temperatures (EGT’s) reach a level greater than or equal to the set level, the
OutLook will automatically lower the horsepower and, in turn, bring EGT’s back down to a safe level. This feature has
been designed to save the integrity of an engine by preventing unsafe engine temperatures.
The default de-fuel level temperature is 1200˚F. If you do not have a Pyrometer Probe hooked up to the
OutLook, it acts as though your EGT’s are below 100° F and this safety feature will not work. Therefore your
engine is susceptible to overheating with the addition of performance upgrades.
SET TRANSMISSION DE-FUEL LEvELS Use this feature to pre-
set an automatic de-fuel level for your vehicle. We recommend
setting a de-fuel temperature level of 230ºF. The default de-fuel
level is set to 180 ºF.
DISPLAy AND ERASE DTC’S If you see a check engine light come on or the vehicle seems to be running
abnormally, you will want to use this feature to see if any Diagnostic Trouble Codes appear. Use this fea-
ture to display the codes and also to erase them from the vehicle’s computer. If the vehicle has recur-
ring trouble codes, research the origin of the code and consult a tech support expert on how to fix the
code. For more information on DTC codes go to
For a full listing of Diagnostic Trouble Codes go to:
www.bullydog.com/DTC.php
vIEw LAST 10 READINGS This feature lets you view the last
Pyro readings taken per key cycle, the last 10 Pyro readings
taken per key cycle, the last 10 boost readings per key cycle, and
if the features are available to your vehicle it will show you your
last 10 quarter mile runs and 0-60 runs. You can also erase the
last ten readings. See Clear Peak Values below to erase.
vIEw ALL TIME HIGHS
Select this and then choose to see your
five all time best 0-60 times and quarter mile times. You can
also choose to erase your all time highs to make room for new
ones. See Clear Peak Values below to erase.
NOTE: Pyrometer Probe Calibration Procedure is found on page 24