Bully Dog OutLook Installation Manual - Harness Description
3
Intr
oduc
tion
OutL
ook Installa
tion
Oper
ating Instruc
tions
Pyr
omet
er P
robe C
alibr
ation
Troubleshooting
Note: Included with this product are at least three individual wiring harnesses. Please see the
name, pictures, and descriptions of each of the harnesses below. The instructions for your truck
in this manual will refer to the different harnesses by name.
OBD II HARNESS: The OBD II Harness, page 2 #6,
has green a plug with female pins and male shell,
which connects to the OutLook Main harness that
has male pins and female shell. In addition to the
green plug on the OBD II Harness, the yellow wire
which is the Power Wire for the Outlook monitor. On
the opposite end of the OBD II Harness is the OBD II
connector, a rectangular plug in appearance from
which the OBD II Harness is named.
OUTLOOK MAIN HARNESS: The OutLook monitor
main harness, page 2 #1, has an OutLook monitor on
one end and two green connectors, one with female
pins and male shell and one with male pins with a
female shell, at the other end. Of the green connec-
tors on the Outlook Main harness, the one with the
male pins and female shell connects to the OBD II
Harness as described above. The second green con-
nector, the one with the female pins and male shell,
connects to a Sub-Harness if your truck uses one. Also on the same end as the two green connectors, the OutLook
Main harness has two sets of thermocouple wires labeled Pyro 1 and Pyro 2, which can connect to two different
pyrometers. Finally, on the OutLook Main harness is a single black wire. This black wire comes from the factory
connected to the Pyro 2 connections and is used as a ground for unused pyrometer probe wires on the OutLook
Main harness.
PyROMETER PROBE: The Pyrometer Probe, page
2 #3, is a steel braded cable with a pyrometer probe
tip on one end and red and yellow wire connections
on the opposite end.
OBD II Harness (#6)
OutLook Main (#1)
Pyrometer Probe (#3)
HARNESS DESCRIPTION
Harness Description