CADDX NetworX NX-8 User Manual - page 10
6
Ready
Light
The ready light is "on" when the system is ready to arm and "flashes" if ready to
force arm. The ready light is off when the system is not ready to arm because of
a zone(s) being faulted.
Stay Light
The stay light and instant lights are "off" when the entry/exit door(s) are delayed.
The stay light and instant lights are "on" when armed in the Stay condition and
the entry/exit door(s) have no delay. (See "Arming System in Stay Mode", page
8.) The doors can be changed from instant to delay (toggled) by pressing the
[STA
Y]
key when the system is armed.
Zone Light
The zone lights are "off" when everything is normal. A zone light will be "on" if the
zone has been bypassed. If a zone light is "flashing", that zone is in alarm or has
been faulted. If a zone light is "flashing" rapidly, it means that the zone is in a
trouble condition. Trouble conditions are:
Tamper
Hardware
Low battery
Loss of supervision
(A combination of Alarm/Fault and Tamper/Trouble will produce a rapid "flashing"
light for a short period of time, followed by a slow "flashing" light.)
EMERGENCY ACTIVATION KEYS
[ + ]
Auxiliary Emergency
[.)
Police
NOTES: You must hold these keys for 2 seconds to activate these functions.
Your system may not be programmed for these activation keys,
so
check
your keypad door.
You should press these keys only in an emergency situation
that requires response by emergency personnel. If your system is programmed
for these functions, the following reports can be sent.
Fire Key
-
This key can activate the fire alarm when pressed for two seconds.
If
your system is connected to a monitoring center, an emergency report could be
sent to that center.
Auxiliary Emergency Key
-
This key can activate the auxiliary alarm when
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be sent to that center.
Police (Panic/Hold-Up) Key
-
This key can sound a local audible alarm when
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be transmitted to that center.
NOTE:
Some Panic/Hold-
Up alarms are programmed to be silent at the protected site while reporting an
alarm to the monitoring center. Check with your installing company to determine
how your security system will respond to the Panic/Hold-Up activation.