CADDX NetworX NX-8 User Manual - page 12
8
KEYPAD FUNCTIONS
ARMING YOUR SYSTEM IN THE "AWAY" MODE
AWAY is used when the user is away from the premise and wants the interior
protected. Listed below are the steps to arm in the AWAY Mode:
Step 1
Close all protected doors and windows.
•
Ready light will be on or flashing when all protected zones and
sensors are secure. NOTE: If any zones are bypassed, a
sensor in that zone can be violated without affecting the
ready light.
•
The security system will not arm if the ready light is not on or
flashing.
•
If the power light is off, you have no AC power. Restore power
if possible. If not, contact your installing company listed on
page 1 of this booklet for service.
Step 2 Enter your 4 or 6 digit user code to arm the system.
•
The armed and exit lights will illuminate.
•
You may now leave the building.
Note: The exit light will flash rapidly for the last 10 seconds of the exit delay
as a warning to the user that the exit time is about to expire. The user may
wish to disarm and rearm the system if more time is needed.
ARMING SYSTEM IN "STAY" MODE
STAY is used when the user is inside the premise and wants protection around
the perimeter. Listed below are the steps to arm in the STAY Mode:
Step 1 Close all protected doors and windows.
• Ready light must be on or flashing when all protected zones
and sensors are secure. NOTE: If any zones are bypassed,
a sensor in that zone can be violated without affecting the
ready light.
•
The security system will not arm if the ready light is not on or
flashing.
•
If the power light is off, you have no AC power. Restore power
if possible. If not, contact your installing company
listed on page 1 of this booklet for service.
\
Step 2 Enter your 4 or 6 digit user code. (Optional, if programmed.)