CADDX NetworX NX-8 User Manual - page 16
12
ASSIGNING USER CODE AUTHORITY LEVELS
Assign authority levels to users by following the steps below. Assign user codes
before assigning authority levels.
Step 1
Press the
[*]
key.
Step 2
Press the
[6]
key.
Step 3
Enter a "Master Arm/Disarm Code".
NOTE: Someone changing the authority of another
person can only add or remove partition
authorization for partitions to which they have
access.
Step 4
The ready light will flash.
Step 5
Enter the 2 digit "user number'' to be assigned
authority (The ready light is solid and the instant light
will flash).
Step 6
Lights illuminated indicate the authority levels
assigned to this code. An explanation of the lights is
listed below. You may toggle (turn on/off) the authority
level by pressing the number for that authority level.
LIGHT
AUTHORITY LEVELS IF LIGHT 8 IS OFF
1
Reserved (Note: Do not change if on.)
2
Arm Only
3
Arm Only After Close Window
4
Master Arm/Disarm (can program other codes)
5
Arm/Disarm
6
Bypass Zones
7
Open / Close Reporting
8
If this light is on, this code is programmed as a
function code. Do not change, Press [#) - [#) to exit.