CADDX NetworX NX-8 User Manual - page 18
14
CHANGE PARTITION - Optional
Step 1 Press the
[*I
key.
Step 2 Press the [1) key.
Step 3 Press a NUMBER key between 1 and 8 to change partitions
momentarily.
Step 4 If no other key is pressed, it will go back to its standard partition in
ten seconds.
Step 5 If another key is pressed, the system will remain in the new partition
until no keys have been pressed for 60 seconds.
VIEW ALARM MEMORY
Step 1
Press the
[*I
key.
Step 2
Press the [3) key to display the zone(s) on the keypad that created
the last alarm.
Step 3 The ALARM MEMORY feature will flash those zones that created alarms
and will light steady those zones that were bypassed during the last
alarm.
TEST FUNCTION - Optional
If programmed, this function will perform a battery test, communicator test,
and/or a siren test.
Step 1
Press the
[*I
key.
Step 2 Press the [4) key. The test will be performed as programmed.
Step 3 If the siren test is performed, enter a user code to silence the siren.
No alarms will be sent and no reports will be sent unless a communicator test
is performed, at which time a test signal will be sent.
RESET SMOKE DETECTORS
Step 1 Disarm the system if not disarmed.
Step 2
Press the
[*I
key, followed by the [7) key.
Smoke detector reset has now been performed.
SETIING THE SYSTEM CLOCK
Step 1
Press the
[*l
key.
Step 2 Press the [9] key.