CalAmp ITC 220 Installation Manual - page 49
ITC 220 Base Station Transceiver Installation Guide PN 133991 Rev. A
| Page 43
D.2 TO CONFIGURE THE COMPUTER ETHERNET 2 INTERFACE FOR COMMUNICATION WITH THE
TRANSCEIVER LAN PORT
1. On the computer, click Start, Control Panel, Network Connections, and then Local Area Connection.
There will be one Local Area Connection icon for each Ethernet port on the computer. Click the Local Area
Connection icon that corresponds to the second Ethernet port.
2. The Local Area Network Connection Status window opens. Click Properties and the Local Area Connection
Properties window for the second Ethernet connection opens.
Figure 20 Local Area Connection Properties window for Ethernet 2 connection
3. On the General tab, click on Internet Protocol (TCP/IP) to select it (you may have to scroll down the items list to
see it—do not remove the check mark) and then click Properties.