CalAmp ITC 220 Installation Manual - page 75
ITC 220 Base Station Transceiver Installation Guide PN 133991 Rev. A
| Page 69
DSP_CMD,BAC,2
SCHED,I,6,L1_TEST,GET,ERRCOUNTS,3,3
where:
value equals the desired frequency of operation.
Once observation of radio performance is complete, turn off transmit operations by typing:
L1_TEST,STOP
I.4 PUT A TRACE ON A FEATURE
A trace enables you to monitor and log a specific activity of a ITC radio transceiver. Examples of traceable activities are
port activity, RF link activity, and forward-error-correction (FEC) activity. You can save traces in a log file.
Note: Heavy tracing can affect radio performance. Do not leave traces running at the site.
Table 12 Brief descriptions of available trace features
Feature
Description of traced data and notes
0-16
All activity on a selected I/O port
CLASC
Class C time and location messages
CLASD
Information about Class D messages
DEBUG
Variety of diagnostic data on ITC RADIO activity
DLOG
Replaces DSP_CMD,LOG,on/off and displays the DSP status log
DSP
Trace messages transferred from the DSP via the HPI interface
ETH
Information about the Ethernet connection status
EVENT
Event activity
GPS
Activity in the GPS protocol device driver
HRX
Information about the HRX messages
IDLE
Transmitted and received Base Beacons
ISMP
Information about ISMP messages
NOISE
Sampled (every second) and averaged (every five minutes) RF noise levels
RF
Activity on the RF link
RSSI
Signal strength indicators
RX
Hex dump of data being received through the RF receivers
TX
Hex dump of transmit date being sent to the RF transmitter