CalAmp ITC 220 Installation Manual - page 76
ITC 220 Base Station Transceiver Installation Guide PN 133991 Rev. A
| Page 70
To trace an activity:
1. Use Category 5 or better Ethernet cable to connect the correct computer Ethernet port to the transceiver’s MAINT
port.
2. The Ethernet port must be configured to communicate with the MAINT port. See
D.1 To Configure the Computer
Ethernet 1 Interface for Communication with the Transceiver MAINT Port
.
3. On the computer, open the XtermW application.
4. Specify the transceiver port you want to communicate with: Click Send, click Command, and then type:
TRACE,port,maint
where:
TRACE is the trace command,
port is a subcommand, and
maint refers to the MAINT port.
5. Click OK.
6. Select the trace feature and output destination: Click Send, click Command, and then type:
TRACE,level,feature,destination
where:
TRACE is the trace command,
level is a number from 0 to 7,
feature is the name of the feature you want to trace, and
destination is the location of the trace output, which can be port, file, or both. If you do not enter a
destination, the trace output is sent to the port only.
7. Click OK.
To suspend a trace:
1. In XtermW, click Send, Click Command, and then type:
TRACE,SUSPEND
2. Click OK.
To resume a trace:
1. In XtermW, click Send, click Command, and then type:
TRACE,RESUME
2. Click OK.