Cam Sat CAM-9 Operating manual - page 10
10
Method for setting the transmission rate and data format
1 . In order to get to the settings, enter the device menu by holding the
ENTER button [I] for three seconds (until
appears on the display) .
2 . You can switch between the menu options (
, , ) by pressing the
ENTER button [I] shortly .
3 . To enter a specific submenu, press the SET button [H] .
4 . To exit a menu (return to the main menu), hold the ENTER button [I]
again for 3 seconds (until the display turns off).
Setting the transmission rate
In order to set the transmission rate, select the ,
option from the menu . The display will show the currently set transmission
rate in the following format: - 1200 bps; - 2400 bps; - 4800 bps;
- 9600 bps; - 19 200 bps
Select the proper option with a short press of the ENTER button [I] . To
confirm the selection, hold the SET button [H] for 3 seconds; the display
will start blinking, indicating that the settings are being saved to the
device memory . Then, the device will return to the main MENU .
Setting the data format
In order to set the data format, select the
option from the menu . The
display will show the currently set data format:
- 8n1; - 8o1; - 8e1
Select the proper option with a short press of the ENTER button [I] . To
confirm the selection, hold the SET button [H] for 3 seconds; the display
will start blinking, indicating that the settings are being saved to the
device memory . Then, the device will return to the main MENU .