Cam Sat CAM-9 Operating manual - Advanced Settings
12
Setting the video operating channel remotely
In order to set the video transmission operating channel (for a specific
transmitter) remotely from the CAM-9 M Rx receiver level,
do the following:
1 . Select the
option from the main menu .
2 . Select the identification number of the transmitter whose video
transmission operating channel you intend to change with the ENTER
button [I] and then confirm the selection by holding the SET button [H] .
3 . The receiver will communicate with the transmitter and the video
transmission operating channel currently set in the transmitter will
appear on the display .
4 . Select the desired operating channel with the ENTER button [I] and then
confirm it with the SET button [H] .
5 . If the selected operating channel appears on the display [B] blinking,
then it has been configured properly. If the , symbol appears instead,
it indicates a transmission error (repeat steps from 1 to 4)
6 . The device will return to the main menu .
Setting the data transmission parameters remotely
In order to set the data transmission parameters (data rate and format)
remotely from the CAM-9 M Rx receiver level, follow the instructions
in the [Method for setting the transmission rate and data format]
section at page 10 . When the radio link parameters are being set, the
receiver, if its memory contains transmitters assigned to it, automatically
communicates with the transmitters and the entire network is configured
according to the CAM-9 M/S Rx receiver parameters .
Advanced settings
Testing the data link
In order to test the correctness of data transmission between the CAM-
9 M Rx receiver and the CAM-9 transmitters, select the option from
the main menu . The procedure will commence automatically . Testing can
be conducted both from the receiver and transmitters levels .
When the testing is completed, the result will appear on the display . The
display method depends on whether the testing was conducted from the
transmitter or receiver level .