Cam Sat CAM-9 Operating manual - page 13
13
Testing from the CAM-9 Tx transmitter level
- If, after testing is completed, the display alternates between (OK)
and the transmitter’s ID number, it indicates a correct transmission .
- If , appears on the display, it indicates a transmission error (check
the connections and test again) .
Testing from the CAM-9 M Rx receiver level
- If, after testing is completed, the display alternates between
(OK)
and the number of transmitters entered into memory, it indicates
a correct transmission .
- If the display alternates between and a number, it indicates
a transmission error between the receiver and the transmitter with
this ID number .
Removing a transmitter from the CAM-9 Rx receiver memory
- If there is a need to turn one of the transmitters off permanently
(removal, damage), it should be deleted from the CAM-9 M Rx
receiver memory . In order to do this, select the option from the
main menu in the receiver .
- Next, select the ID number of the transmitter to be deleted with the
ENTER button [I] and confirm the selection by holding the SET button
[H] . The transmitter will be deleted from the device memory and will
no longer be visible during testing, setting parameters, etc .
Restoring the device to default settings
- In order to reset the transmitter or receiver to the default settings,
disconnect the device’s power supply, press the ENTER button and
connect the power supply again .
- The display will count from 5 to 1, the ENTER button should be
held during that entire time . The device will reset itself to the
default settings .