CAME ZLJ24 Installation Manual - page 19
0
0
D
B
A
B
D
B
B
D
A
D
E
F H
G
M
N
O
O
O
C
C
I
L
p.
1
9
19
- M
an
u
al
c
od
e:
F
A
0
0
0
3
8
-E
N
F
A
000
3
8
-E
N
v
.
33
- 0
2
/2
0
17 - © C
am
e S
.p.
A
. - T
h
e m
an
u
al
's c
onte
nts m
ay b
e e
d
ite
d at a
ny ti
m
e w
ith
ou
t n
oti
ce
.
DIAGRAM OF THE SLOWDOWN AND FINAL APPROACH POINTS AND FOR THE ENCODER DEVICE
The run area and slowdown and approach points are tested according to the parameters set forth by Technical Standards EN 12455 and
EN 12453 for compliance with the impact forces generated by the running leaves.
A = Normal speed
B* = Slowed-down speed
C = Encoder intervention zone with movement inversion
D = Encoder intervention zone with movement stopped
E = Opening slow-down starting point [M1 Appr.AP %]
F = Closing slow-down starting point [M1 Slow.CH%]
G = Opening slow-down starting point [M2 Slow. AP %]
H = Closing slow-down starting point [M2 Slow. CH%]
I** = Closing approach starting point [M1 Appr.CH %]
L** = Closing approach starting point [M2 Appr.CH %]
M = Opening slow-down starting point [M1 Appr. AP %]
N = Opening slow-down starting point [M2 Appr. AP %]
O = Strike plates
* Minimum 600 mm from the strike plate.
** Set the fi nal approach percentage for the [M1 Appr.CH %] function for M1 and [M2 Appr.CH %] for M2 from the [ENCODER] menu so
as to obtain a distance of between 1 and 50 mm maximum from the fi nal strike plate point.
DISMANTLING AND DISPOSAL
Always make sure you comply with local laws before dismantling and disposing of the product. The packaging materials (cardboard, plastic, and
so on) should be disposed of as solid urban waste, and simply separated from other waste for recycling.
Other components (control boards, batteries, transmitters, and so on) may contain hazardous pollutants. These must therefore be disposed of
by authorized, certified professional services.
DISPOSE OF PROPERLY!
PERTINENT REGULATIONS
This product complies with the law.