Canmax CM-520 User Manual - page 100
Enter 100 End
*/$%ENTR* *ZEND*
6. Memory / Bluetooth General Setting
6-2-3 Scan Activation Time
In general, after Scan Button is pressed down, LED light will emit a stream of
light for a scan attempt. This parameter is thus used to specify activation
duration which indicates the amount of time LED light will stays on after Scan
button is held.
*C5DE0*
Configuration Range Unit
Default Setting
5 Secs ~ 4 Min 15 Secs
1 Secs
10 Secs
6-2-4 Composite Triggers Functionality
ctionality
Some supplementary functions are necessarily executed by using composite
triggers though Scan Button primarily serves to scan barcodes, and Small
Trigger to initiate data transmission. In Bluetooth mode, Bluetooth paring is an
extra function which can be initiated by pressing Small Trigger and Scan
Button in a specified sequence described below: while holding Small Trigger till
the blue LED light starts flashing rapidly, press down Scan Button at the same
time and then release both buttons. Scan the appropriate label to Pair or
disable pairing functionality
.
*C4280*
Disable
*C4281*
Pair
Procedure
(A) Scan “Enter” barcode
(B) Scan “Scan Activation Time” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
6-2-4 Composite Triggers Functionality
6-2-3 Scan Activation Time