Canmax CM-520 User Manual - page 86
Enter 86 End
*/$%ENTR* *ZEND*
6. Memory / Bluetooth General Setting
6-1-20 Normal Vibrator
Normal Event Vibrator is used to give a vibration signal whenever certain
operations, Scan the appropriate barcode to enable or disable Normal Event
Vibrator.
*BE620*
Disable
*BE621*
Enable
6-1-21 Viberator Time
Please follow the below steps to specify the length of time the device stays in a
state of vibration when a barcode is decoded successfully
*BFAE0*
Configuration Range
Unit
Default Setting
0.02 Secs ~ 2.55 Secs
0.01 Sec
0.05 Secs
Procedure
(A) Scan “Enter” barcode
(B) Scan “Viberator Time” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
6-1-20 Normal Vibrator
6-1-21 Viberator Time