Canmax CM-520 User Manual - page 33
33
4. Memory / Bluetooth Mode
*/$%MTX*
(Send)
4-1-3 Erase barcode data (single data/ all data)
Erase single data:
While holding Small Trigger and point to the scanned barcode, this action
will erase the last previous saved barcode data
in the memory.
Erase all data:
1. While holding Small Trigger till Orange LED turns rapidly blinking,
2. Press down Scan Button
3. Release Scan Button and Small Trigger together,
alll barcode data saved in the memory will be erased.
OR
By scanning the send barcode as below:
*/$%MCR*
(Clear)
Clear all barcode data in the memory
Caution: Scan the “Clear” Barcode will erase all the barcode
data saved in the memory; make sure you have back up all
the barcode data before performing this action.
4-1-3 Erase barcode data (Single data / ALL data)