Canon DADF-M1 Service Manual - page 68
of
110
Chapter 3
3-10
F-3-54
2) Remove the locking motor drive unit [3].
- 3 screws [1]
- 1 connector [2]
F-3-55
3) Remove the cooling fan [3].
- 1 screw [1]
- 1 connector [2]
F-3-56
4) Loosen the 2 screws [1], and move the feed motor [2] down; then, tighten
the 2 screws [1] you have loosened.
F-3-57
When mounting it, loosen the screws [1] to put it back to its initial position.
5) Remove the feed roller [3].
- 1 connector [1]
- 2 screws [2]
F-3-58
When mounting it, be sure that that timing belt [1] is properly attached to the
pulley [2].
F-3-59
6) Remove the platen downstream roll unit [2].
- 1 screw [1]
F-3-60
7) Remove the platen roller [4].
- 1 belt [1]
- 2 resin E-rings [2]
- 2 bushings [3]
[1]
[2]
[2]
[2]
[3]
[1]
[1]
[2]
[3]
[1]
[2]
[3]
[1]
[1]
[2]
[1]
[2]
[2]
[3]
[1]
[2]
[1]
[2]