Canon DADF-M1 Service Manual - page 77
Chapter 3
3-19
F-3-109
2) Remove the ADF driver PCB [3].
- 5 connectors [1]
- 2 screws [2]
F-3-110
3.5.5 Separation Sensor
3.5.5.1 Before Removing the Separation Sensor
0017-6544
1) Remove the inside cover. (page 3-2)Reference[Removing the Inside
Cover]
3.5.5.2 Removing the Separation Sensor
0017-6545
1) Remove the separation rear sensor [3].
- 2 screws [1]
- 1 connector [2]
F-3-111
F-3-112
Be sure to perform sensor adjustment if you have replaced the sensor PCB.
3.5.6 Read Sensor
3.5.6.1 Before Removing the Read Sensor
0017-6546
1) Remove the front cover. (page 3-1)Reference[Removing the Front Cov-
er]
3.5.6.2 Removing the Read Sensor
0017-6614
1) Open the open/close guide [1]; then remove the feed guide [4].
- 2 screws [2]
- 1 connector [3]
F-3-113
2) Remove the read sensor [3].
- 2 screws [1]
- 1 connector [2]
[1]
[1]
[2]
[1]
[2]
[3]
[1]
[1]
[2]
[2]
[3]
[1]
[2]
[3]
[1]
[4]
[2]
[3]