Canon DADF-M1 Service Manual - page 71
Chapter 3
3-13
F-3-72
2) Remove the cooling fan [3].
- 1 screw [1]
- 1 connector [2]
F-3-73
3) Loosen the 2 screws [1], and move the feed motor [2] down; then, tighten
the 2 screws [1] you have loosened.
F-3-74
When mounting it, loosen the screws [1] to put it back to its initial position.
4) Remove the feed roller [3].
- 1 connector [1]
- 2 screws [2]
F-3-75
When mounting it, be sure that that timing belt [1] is properly attached to the
pulley [2].
F-3-76
5) Open the open/close guide [1]; then, remove the feed guide [4].
- 2 screws [2]
- 1 connector [3]
F-3-77
6) Remove the E-ring [1], gear [2], and bushing [3].
F-3-78
7) Remove the ring [1], gear [2], and busing [3].
F-3-79
8) Release the pressure spring [1].
[1]
[1]
[2]
[3]
[1]
[2]
[3]
[1]
[1]
[2]
[1]
[2]
[2]
[3]
[1]
[2]
[1]
[4]
[2]
[3]
[1]
[2]
[3]
[1]
[2]
[3]