Canon ImageCLASS 2300 Setup Sheet - page 5
To Use the Machine as a Network Printer
Specifying the Network Settings
IMPORTANT
●
The machine needs to be restarted for the specified settings to become effective. To restart the machine, simply turn the
power OFF, wait for at least 10 seconds, and turn the power ON again.
NOTE
●
For details on specifying network settings, see Chapter 2,“Using a TCP/IP Network (Windows/UNIX),” in the Network
Guide, and Chapter 2,“Setting the Network,” in the Sending Guide.
●
For additional network protocol settings, see the Network Guide.
●
For details on how to input characters, see Chapter 2,“Basic Operations,” in the Reference Guide.
●
For the values of the network settings, consult your network administrator or internet service provider (ISP).
1 Print the printer configuration page:
a. Press [PRINT]
➝
[OK] to take the machine offline.
b. Press [F1] until
c. Press [F2] until
d. Press [F4] to print out the configuration page.
e. If the IP address is correct, proceed to Installing the Printer Driver Software on the next page.
OK
F1
F2
F4
5 Connect the USB cable to the
USB port on the back of the
machine. Connect the other
end of the cable to the USB
port on your computer, and
turn ON the machine’s main
power.
6 When the printer driver is installed, remove the Driver
Software CD-ROM from the CD-ROM drive. Select [Yes, I want
to restart my computer now.] and click [Exit] to restart your
computer.
7 If you want to install the fax driver, proceed to
.
USB port