D-Link DES-3250TG User Manual - Switch Information

D-Link DES-3250TG Standalone Layer 2 Switch

switch’s ports. There are no entries in the 

Management Station IP Addressestable, by 

default 

− so any management station can access 

the switch. 

Admin. State 

This setting allows the IP interface named 

“System” to be enabled or disabled. 

Switch Information 

Click the Switch Information link in the Configuration menu.  

Figure 7- 2.  Switch Information (Basic Settings) window 

This window shows which (if any) external modules are installed, and the switch’s MAC Address (assigned by the factory and 

unchangeable). In addition, the Boot PROMVersion and Firmware Version numbers are shown. This information is helpful to 

keep track of PROM and firmware updates and to obtain the switch’s MAC address for entry into another network device’s 

address table – if necessary. 

You can also enter the name of the System, its location, and the name and telephone number of the System Administrator. It is 

recommended that the person responsible for the maintenance of the network system that this switch is installed on be listed 

here. 

Advanced Settings 

Click Advanced Settings on the Configuration menu:  

33