D-Link DES-3250TG User Manual - Static Arp Settings
D-Link DES-3250TG Standalone Layer 2 Switch
numerical value of their respective MAC
addresses.
Auto
Switches in the stack will be assigned a unit
ID using a comparison of the numerical value
of the Switch’s MAC address. The lowest
MAC address in the Switch stack will
become Unit 1 (the Master Switch), the next
highest MAC address will become Unit 2,
and so on. This is the Switch’s default mode.
ID
The field displays the Switch’s order in the
stack. The Switch with a Unit ID of 1 is the
Master Switch
MAC Address
Thefielddisplays the unique address of the
Switch assigned by the factory
Port Range
The field displays the total number of ports
on the Switch. Note that the stacking port is
included in the total count
Mode
The field displays the method used to
determine the stacking order of the Switches
in the Switch stack
Version
The field displays the version number of the
stacking firmware
RPS Status
This field displays the status of the
Redundant Power Supply for the
corresponding switch.
Static ARP Settings
The Address Resolution Protocol (ARP) is a TCP/IP protocol that converts IP addresses into physical addresses. This table
allows network managers to view, define, modify and delete ARP information for specific devices.
Static entries can be defined in the ARP Table. When static entries are defined, a permanent entry is entered and is used to
translate IP address to MAC addresses.
To open the Static ARP Settings window, open the Configuration, menu.
Figure 7- 10. Static ARP Settings window
42