D-Link DES-3526 - Switch - Stackable User Manual - Layer 3 Ip Networking
xStack DES-3526 / DES-3526DC Layer 2 Stackable Fast Ethernet Managed Switch User Manual
104
Layer 3 IP Networking
Static ARP Table
The Address Resolution Protocol (ARP) is a TCP/IP protocol that converts IP addresses into physical addresses. This table allows
network managers to view, define, modify and delete ARP information for specific devices.
Static entries can be defined in the ARP Table. When static entries are defined, a permanent entry is entered and is used to
translate IP address to MAC addresses.
To open the Static ARP Table open the Configuration folder, and then open the Layer 3 IP Networking folder and click on the
Static ARP Table link.
Figure 6- 87. Static ARP Settings window
To add a new entry, click the Add button, revealing the following window to configure:
Figure 6- 88. Static ARP Table – Add a New Entry window
To modify an entry, click the Modify button, revealing the following window to configure:
Figure 6- 89. Static ARP Table - Modify
The following fields can be set:
Parameter
Description
IP Address
The IP address of the ARP entry.
MAC Address
The MAC address of the ARP entry.
After entering the IP Address and MAC Address of the Static ARP entry, click Apply to implement the new entry. To completely
clear the Static ARP Settings, click the Clear All button.
NOTE: The Switch supports up to 255 static ARP entries.