D-Link DES-3526 - Switch - Stackable User Manual - Snmp Host Table
xStack DES-3526 / DES-3526DC Layer 2 Stackable Fast Ethernet Managed Switch User Manual
132
Parameter
Description
Community Name
Type an alphanumeric string of up to 33 characters that is used to identify members of an
SNMP community. This string is used like a password to give remote SNMP managers
access to MIB objects in the Switch's SNMP agent.
View Name
Type an alphanumeric string of up to 32 characters that is used to identify the group of MIB
objects that a remote SNMP manager is allowed to access on the Switch. The view name
must exist in the SNMP View Table.
Access Right
Read Only - Specifies that SNMP community members using the community string created
can only read the contents of the MIBs on the Switch.
Read Write - Specifies that SNMP community members using the community string created
can read from, and write to the contents of the MIBs on the Switch.
To implement the new settings, click Apply. To delete an entry from the SNMP Community Table, click the
under the
Delete heading, corresponding to the entry you wish to delete.
SNMP Host Table
Use the SNMP Host Table window to set up SNMP trap recipients.
Open the SNMP Manager folder, located in the Security Management folder and click on the SNMP Host Table link. This
will open the SNMP Host Table window, as shown below.
To delete an existing SNMP Host Tableentry, click the corresponding X under the Deleteheading.
To display the current settings for an existing SNMP Group Table entry, click the blue link for the entry under the Host IP
Addressheading.
Figure 7- 37. SNMP Host Table window
To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand corner of the window. This will
open the SNMP Host Table Configuration window, as shown below.
Figure 7- 38. SNMP Host Table Configuration window
The following parameters can set:
Parameter Description
Host IP Address
Type the IP address of the remote management station that will serve as the SNMP host for the
Switch.
SNMP Version
V1 - To specifies that SNMP version 1 will be used.
V2 - To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv - To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
security level.
V3-Auth-NoPriv - To specify that the SNMP version 3 will be used, with an Auth-NoPriv security
level.
V3-Auth-Priv - To specify that the SNMP version 3 will be used, with an Auth-Priv security level.