D-Link DES-3526 - Switch - Stackable User Manual - Enable Method Lists
xStack DES-3526 / DES-3526DC Layer 2 Stackable Fast Ethernet Managed Switch User Manual
117
Enable Method Lists
The Enable Method List Settings window is used to set up Method Lists to promote users with user level privileges to
Administrator (Admin) level privileges using authentication methods on the Switch. Once a user acquires normal user level
privileges on the Switch, he or she must be authenticated by a method on the Switch to gain administrator privileges on the
Switch, which is defined by the Administrator. A maximum of eight Enable Method Lists can be implemented on the Switch, one
of which is a default Enable Method List. This default Enable Method List cannot be deleted but can be configured.
The sequence of methods implemented in this command will affect the authentication result. For example, if a user enters a
sequence of methods like TACACS - XTACACS - Local Enable, the Switch will send an authentication request to the first
TACACS host in the server group. If no verification is found, the Switch will send an authentication request to the second
TACACS host in the server group and so on, until the list is exhausted. At that point, the Switch will restart the same sequence
with the following protocol listed, XTACACS. If no authentication takes place using the XTACACS list, the Local Enable
password set in the Switch is used to authenticate the user.
Successful authentication using any of these methods will give the user an "Admin" privilege.
NOTE: To set the Local Enable Password, see the next section, entitled Local Enable Password.
To view the following table, click Security Management > Access Authentication Control > Enable Method Lists:
Figure 7- 16. Enable Method List Settings window
To delete an Enable Method List defined by the user, click the X under the Delete heading corresponding to the entry desired to be
deleted. To modify an Enable Method List, click on its hyperlinked Method List Name. To configure a Method List, click the Add
button.
Both actions will result in the same window to configure:
Figure 7- 17. Enable Method List - Edit window
Figure 7- 18. Enable Method List - Add window