D-Link DGS-1210-10P Reference Manual - page 10
1 Product Introduction
D-Link Web Smart Switch User Manual
5
5
Rear Panel
Figure 1.6 – DGS-1210-28 Rear Panel
Power: Connect the supplied AC power cable to this port.
DGS-1210-28P
24-Port 10/100/1000Mbps plus 4 SFP ports Web Smart PoE Switch.
Front Panel
Figure 2.7 – DGS-1210-28P Front Panel
Power LED
: The Power LED lights up when the Switch is connected to a power source.
Pwr Max: The Pwr Max LED lights up when the Switch reaches the maximum power budget defined by the
administrator via PoE System Settings page of Web GUI or the default power budget of 185 Watts.
Reset: By pressing the Reset button for 5 seconds, the Switch will change back to the default configuration
and all changes will be lost.
Mode: By pressing the Mode button, the Port LED will switch between Link/Act and PoE modes.
Port Link/Act/Speed LED (1-24, 25F, 26F, 27F, 28F): When mode LED lights up in Link/Act mode, the port
LEDs indicate a network link through the corresponding port. Blinking indicates the Switch is either sending
or receiving data to the port. When the port LED glows in amber, it indicates the port is running on 10M or
100M. When the port LED glows in green, it is running on 1000Mbps.
Fan: The Fan LED lights green when fans work well, and lights red when fans fail.
CAUTION: The MiniGBIC ports should use UL listed Optical
Transceiver product, Rated Laser Class I. 3.3Vdc.
CAUTION: The ITE is to be connected only to PoE networks
without routing to the outside plant.
Port PoE LED (1-24): When mode LED lights up in PoE mode, the port LEDs indicate powering status over
the corresponding port. DGS-1210-28P can supply up to 30W on port 1- 4, which are marked with black
background color on front panel, for IEEE802.3at compliance PDs.
Rear Panel
Figure 1.8 – DGS-1210-28P Rear Panel
Power: The power port is where to connect the AC power cord.
DGS-1210-52
48-Port 10/100/1000Mbps plus 4 SFP Slot Web Smart Switch.