D-Link DGS-1210-10P Reference Manual - page 100
6 Command Line Interface
D-Link Web Smart Switch User Manual
9
9
5
5
reboot
Purpose
To reboot the Switch. If the Switch is a member of a stack, it may
be rebooted individually, without affecting the other members of
the stack.
Syntax
reboot
Description
The
reboot command reboots the system. All network
connections are terminated and the boot code executes.
Parameters
None.
Restrictions
None.
Example usage:
To restart the Switch:
DGS-1210-52>
reboot
% Device will reboot, please wait a few minutes to re-login.
DGS-1210-52>
reset config
Purpose
To reset the Switch to the factory default settings.
Syntax
res et config
Description
All configurations will be reset to the default settings.
Parameters
None.
Restrictions
None.
Example usage:
To restore all of the Switch’s parameters to their default values:
DGS-1210-52>
res et config
% Device will reboot after reset configuration successfully.
DGS-1210-52>
show ipif
Purpose
To display the configuration of an IP interface on the Switch.
Syntax
s how ipif
Description
The
s how ipif command displays the current IP address of the
switch.
Parameters
None.
Restrictions
None.
Example usage:
To display IP interface settings:
DGS-1210-52>
s how ipif