D-Link DGS-1210-10P Reference Manual - page 106
Appendix B - Technical Specifications
D-Link Web Smart Switch User Manual
1
1
0
0
1
1
Loopback Detection
802.3ad Link Aggregation:
- DGS-1210-10P: Supports max 5 groups
per device and 8 ports per group
- DGS-1210-20: Supports max 10 groups
per device and 8 ports per group
- DGS-1210-28/28P: Supports max 14
groups per device and 8 ports per group
- DGS-1210-52: Supports max 26 groups
per device and 8 ports per group
Port mirroring
SNTP
LLDP/LLDP-MED
IPv6 neighbor Discovery (ND)
L2 Multicast Filtering
VLAN
802.1Q VLAN standard (VLAN Tagging)
Up to 256 static VLAN groups
Asymmetric VLAN
Management VLAN
Auto-Voice VLAN
Auto Surveillance VLAN
QoS (Quality of Service)
Priority queue mapping by :
-
802.1p
-
DSCP
-
ToS
-
TCP/UDP port number
-
IPv6 traffic class
Up to 4 queues per port
Supports Strict / WRR mode in queue
handling
Bandwidth Control
AAA
802.1X port-based access control
Support RADIUS server
ACL
Max 50 ingress ACL profiles
Ingress ACL rules:
- DGS-1210-20/28/28P: 200 rules (each
rule can be associated to a single port or
multiple ports)
- DGS-1210-52: 450 rules
Support different ACL policy packet
contents:
- MAC address
- Ethernet Type
- IPv4 address
- IPv6 address
- ICMP
- IGMP
- TCP/UDP port number
Security
Trusted Host
Port Security:Support 64 MAC addresses
per port
Traffic Segmentation
D-Link Safeguard Engine
Broadcast Storm Control
ARP Spoofing Prevention: Supports max
64 entries
DHCP Server Screening: Able to
configure 5 IP addresses for DHCP server.
SSL: Support v1/v2/v3
Smart Binding
-
Support manual configuration
and
scanning for binding.
- Supports ARP packet inspection as default,
ARP and IP packet inspection as an option.
- Supports DHCP Snooping
OAM
Cable Diagnostics
Reset button (reset to factory default)
Management
Web-based GUI or SmartConsole Utility
D-Link proprietary CLI
SNMP support
DHCP client
Trap setting for destination IP, system
events, fiber port events, twisted-pair port
events
Password access control
Web-based configuration backup
/
restoration
Web-based firmware backup/restore
Firmware upgrade using SmartConsole
Utility & Web-based management
Reset, Reboot
D-Link Green Technology
Power Saving: Enabled by default to save
power:
- By Link Status: Drastically save power
when the switch port link is down. For
example,
no
PC
connection or the
connected PC is powered off.
- By Cable Length: Detects the length of
connected RJ-45 cables and adjusts power
usage accordingly without affecting
performance. Once the RJ-45 connection is
less than 20 meters, the switch will reduce
the power instead of full power, which is
only needed for 100 meters cables.
- By LED Shut-Off: LEDs can be turned
on/off by port or system through schedule.
- By Port Shut-Off: Each port on the system
can be turned on/off by schedule.