D-Link DGS-1210-10P Reference Manual - page 98
6 Command Line Interface
D-Link Web Smart Switch User Manual
9
9
3
3
DGS-1210-52>
config ipif system
Purpose
To configure the System IPv6 interface.
Syntax
config ipif system { ipv6 ipv6address
dhcpv6_client [enable | disable] }
Description
The
config ipif s ys tem command configures the System IPv6
interface on the Switch.
Parameters
ipv6 ipv6address
− Use this parameter to
statically assign an IPv6address to this interface. This address
should define a host address and a network prefix length.
Multiple IPv6 addresses can be configured for a single IP
interface. Ex: 3ffe:501:ffff:100::1/64. The /64 represents the prefix
length of the IPv6 addresses.
dhcpv6_client [enable | disable]
− Specify the DHCPv6 client to
be disabled or enabled.
Restrictions
None.
Example usage:
To configure the IPv6 interface System:
DGS-1210-52>
config ipif S ys tem ipv6 ipv6addres s 3ffe:501:ffff:100::1/64
S ucces s .
DGS-1210-52>
logout
Purpose
To log out a user from the Switch’s console.
Syntax
logout
Description
The
logout command terminates the current user’s session on
the Switch’s console.
Parameters
None.
Restrictions
None.
Example usage:
To terminate the current user’s console session:
DGS-1210-52> logout
NOTE: Save your configuration changes before
logging out.
ping
Purpose
To test the connectivity between network devices.
Syntax