D-Link DI-304 User Manual - The Di-304 Rear Panel
DI-304ISDN Remote Router
10
DI-304
♦
POWER— Comes on as soon as you connect the router to the power
adapter and plug the power adapter into a suitable AC outlet.
♦
STATUS— Should be blinking if the router is functioning properly.
♦
ISDN – LINK— Indicates that the router has an ISDN line connected to
the ISDN interface and it has been successfully initialized.
Note: On some NT1 boxes, the LINK indicator will go off when the ISDN line has been
idle for a while. When the router is dialing or answering a call, it should be on again.
♦
ISDN – B1 and B2— On if there is an active ISDN session on that channel
or if that channel is making or receiving a call.
♦
LINK/ACT – 1 through 4 — These indicators light up when a port is
connected to a powered-on Ethernet/Fast Ethernet station. The LEDs blink
when information is transmitted or received on a port.
♦
100/10M – 1 through 4 — These indicators light up when a port is operating
at 100Mbps. Otherwise, if this indicator is dark and the corresponding
LINK indicator is lit, then the port is operating at 10Mbps.
The DI-304 Rear Panel
DI-304