D-Link DI-304 User Manual - page 20
DI-304ISDN Remote Router
12
Connecting to the Ethernet
A. Connecting to PCs:
1. Attach the Ethernet cable to any P1 ~ P4 port.
2. Connect the other end of the Ethernet cable to your PCs' installed network
interface card (NIC).
3. The LED indicators at both the Ethernet port and the NIC should be ON.
Note:If the Ethernet cable is not long enough to reach your PCs, purchase a longer
straight-through Cat. 5 UTP or STP Ethernet cable.
B. Connecting to an External Ethernet Hub:
1. Attach the Ethernet cable to the Uplinkport.
2. Connect the other end of the Ethernet cable to the external Ethernet hub or switch.
3. The LED indicators on both the Uplink port and the external Ethernet hub or
switch should be ON.
Note:If the Ethernet cable is not long enough to reach the external hub/switch, purchase
a longer straight-through 10BASE-T Ethernet cable, or connect two shorter cables
to create a cable of sufficient length.
Connecting to an ISDN BRI Line
A. S/T-Interface Model
1. Locate the ISDN cable.
2. Plug one of the RJ-45 connectors on the cable into the ISDN port on the rear
panel of the router.
3. Plug the other end of the cable into any of the NT-1 (or NT1 plus) S/T-interface
ports.
B. U-Interface Model
1. Locate the ISDN cable.
2. Plug one of the RJ-45 connectors on the cable into the ISDN port on the rear
panel of the router.