D-Link DSN-1100 User Manual - page 48
38
Chapter 3 Managing Volumes
–
For adjacent disks, click the first one, then hold down the Shift key and click
the last one. The first and last disks, and all the disks between them, get
selected.
–
For non-adjacent disks, click the first one, then hold down the Ctrl key and
click each subsequent disk.
–
To deselect a disk, hold down the Ctrl key and click a disk that is selected.
6. Click Next.
If you selected Stripe/Mirror, Parity, or Stripe, a Stripe Depth screen similar to
the one in Figure 3-16 appears and you should proceed to the next step. Otherwise,
the Volume Size screen appears (see Figure 3-17) and you should skip to step 8.
Figure 3-16. Stripe Depth Screen
7. By default, the Wizard will select the stripe depth (chunk size) for volumes
configured as stripe/mirror, parity, or stripe. If you prefer, use the Stripe Depth
drop-down list to select from one of the commonly used chunk sizes. Click Next.
The Volume Size screen appears (see Figure 3-17).