D-MAX DCC-600F Manual - page 18
18
MOTION DETECTION
ZONE NUMBER AREA1
ZONE STATE OFF
HEIGHT 40 -----|-----
WIDTH 40 -----|-----
MOVE Y 50 -----|-----
MOVE X 50 -----|-----
SENSITIVITY 50 -----|-----
EXIT RET↙
- LEVEL: Use or button to select a level. (LOW / middle / HIGH)
- DWELL TIME: Use left or light button to select a dwell time. (5, 10, 15, 0 or 60 SEC.)
▶ DAY: Color mode enabled.
▶ NIGHT: Black-and-white mode enabled.
▶ EXT: This mode can be use to operate Day & Night that operates to receive the signal of the external
sensor, when using IR camera.
⑤ MOTION DETECTION
The motion detection detects the moving objects in the scene by monitoring changes in brightness level.
You can select the level of sensitivity for motion detection to 4 zones.
- Select [MOTION DET] option on the [CAMERA SETTING] menu.
- Use left or right button to select a [ON] and press setup button. The MOTION DETECTION menu appears.
- Use left or right button to select a zone number (AREA1 ~ AREA4) on the [ZONE NUMBER] option.
- Use left or right button to set up the ON or OFF on the [ZONE STATE] option. If you set to ON, the zone
frame appears on the center of the monitor.
- Use left or right to select an option then use left or light button to adjust the option.
▶ HEIGHT: Enlarge or decrease the vertical size of the zone frame.
▶ WIDTH: Enlarge or decrease the horizontal size of the zone frame.
▶ MOVE Y: Moves vertical position of the zone frame.
▶ MOVE X: Moves horizontal position of the zone frame.
- Use [SENSITIVITY] option to obtain the optimum detection level.
⑥ 3D-DNR setting
- Select [ D-DNR] option.
If pictures are not clear due to noise, use this function to reduce the noise of picture.
- Use left or light button to select a option.
(OFF / LOW / MIDDLE / HIGH)
Notes: