E-MetroTel UCX50 Quick Start Manual - page 10
www.emetrotel.com
Page 9
copyright © 2011 E-Metrotel Global Inc
1.
2.
3.
4.
5.
In order to connect phones on your UC Digital Gateway to a specific UC Server, you must enter the IP address of the UC Server and the port
x
x
x
number used by that server for Nortel phones in the configuration of the UC Digital Gateway.
x
To specify the UC Server to which UC Digital Gateway is connected, perform the following steps:
x
x
Open the UC Digital Gateway Web-based Configuration Utility
x
From the
tab, select
Digital Gateway
Gateway Configuration
In the
field, enter the IP address of the UC Server.
UC
x
Server IP
x
If the UC Server does not use the default port number for Nortel phones (7000), enter the port number in the
field.
x
Port
Press the
button to update the configuration of the UC Digital Gateway.
Save Changes
x
Note: The UC Digital Gateway system does not initiate any communication with UC Server until a
.
x
x
valid license is activated