E-MetroTel UCX50 Quick Start Manual - page 7
www.emetrotel.com
Page 6
copyright © 2011 E-Metrotel Global Inc
1.
2.
3.
4.
5.
6.
7.
8.
To change the host name, the default gateway and/or IP address of DNS servers, perform the following steps:
Open the UC Digital Gateway Web-based Configuration Utility
x
From the
tab, select
System
Network
Press the
button to enter the
page.
Edit Network Parameters
Network Parameters
Enter a fully qualified domain name for the UC system (e.g., ucxgw.emetrotel.org)
x
Enter the default gateway of your local subnet (typically this is the IP address of your router)
If your router can relay DNS requests, specify the IP address of your router also in the
field. Otherwise, enter the IP
Primary DNS
address of your preferred DNS server.
You can keep the default public DNS server (8.8.8.8) as the secondary DNS server. Alternatively, you can change the Secondary DNS
field to an alternative DNS server.
Press the
button to update the network configuration of the UC system.
Save
x
3.4. Setting the Date, Time and Time Zone
The date, time and time zone configured on your UC systems is used for several features:
x
The system time of UC Digital Gateway is used for the date and time shown on the display of Nortel digital phones connected to the
x
gateway system
The system time of UC Digital Gateway is used for log files generated on the gateway system
x
The system time of UC Server is used for the date and time shown on the display of Nortel IP phones
x
The system time of UC Server is used for CDR records and call log entries
x
The system time of UC Server is used for log files generated on the server system
x
If your UC Digital Gateway is connected to the Internet, Network Time Protocol (NTP) is used to keep the system time accurate. In that case, you
x
have to configure just the correct time zone. If your system is not connected to the Internet, you should make sure that you set the date, time and
time zone correctly.