E-MetroTel UCX50 Quick Start Manual - page 4
www.emetrotel.com
Page 3
copyright © 2011 E-Metrotel Global Inc
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
If you have the newer style BCM hard disk bracket (one where the hard drive was mounted from the top of the bracket), skip the next
step (i.e., do not use the conversion bracket).
Secure the SSD to the 2.5” to 3.5” conversion bracket with four screws that were included with the SSD. Please do not use different
screws that do not match – doing so could damage the SSD!
If you have the combined SATA power and data cable, use the proper orientation and connect the cable to the SSD.
If you have two separate cables, first make sure the notch on the power cable is properly aligned with the notch on the corresponding
SSD connector and connect the power cable to the SSD. Then make sure the notch on the SATA data cable is properly aligned with the
notch on the corresponding SSD connector and connect the data cable to the SSD.
If you have
, place the SSD with the conversion bracket into the hard disk bracket and secure it on
the older style BCM hard disk bracket
the sides with four screws that you removed during the hard drive removal.
If you have
, place the SSD into the bracket and secure it from the bottom with four screws that
the newer style BCM hard disk bracket
were included with the SSD. Please do not use different screws that do not match – doing so could damage the SSD!
Insert the hard disk bracket with the SSD back into the BCM case (make sure that fan wires are properly routed through the cutout in the
bracket).
Note: Some BCM systems were shipped with two fans, but typically there is only one fan installed. If you have a single fan, it should be
installed in the far left corner when facing the BCM front side with connectors (or in the bottom right corner if you turn the system around
as shown in the picture above).
Reconnect the red SATA data cable and the power cable to the main board.
Place fan wires back into the clip(s) on the hard disk bracket while making sure there is no slack.
If you have the newer style BCM hard disk bracket, fasten it to the BCM case with two screws that were used to attach the bracket.
2.4. Closing the BCM Main Unit
While facing the BCM front side (the one with connectors), place the top of the BCM case onto the unit with side edges aligned and with
the front side positioned back by about ¼”.
Slide the top of the case to the front until it snaps into place.